Missing euro plug/power adapter CD and manual

Overview:

The PSoC Development Kit includes an In-Circuit Emulator (ICE) which consists of a base unit, USB 2.0 cable, and power supply. The base unit is connected to the host PC via the USB port. The ICE is driven by the Debugger subsystem of PSoC Designer. This software interface allows the user to run, halt, and single step the processor. It also allows the user to set complex event points. Event points can start and stop the trace memory on the ICE, as well as break the program execution. In addition to the Development Kit, different Emulation Pods are available to support the range of devices in the PSoC family. They plug into (or are soldered onto) the user’s circuit board to provide the physical interface. Pods are available for low-cost expansion of the ICE-Cube capability.

The ICE-Cube also serves as a single-site device programmer via an ISSP (In-System Serial Programming) Cable and MiniEval board included in the kit. The MiniEval board is a programming and evaluation board which connects to the ICE-Cube via an ISSP Cable and allows programming of DIP devices. There are also other Programming boards available for programming other packages. The MiniEval also includes LEDs and a POT for simple evaluation and demonstration.

Development Kit Includes:

• ICE-Cube In-Circuit Emulator
• ISSP Cable
• USB 2.0 Cable
• Blue Cat-5e Cable
• CY3250 flex cable
• Backward-compatibility adapter
• 12-V 1-A adapter and Euro-Plug Adapter
• CY3215A-DK kit CD
• Quick start guide

Supports following 8 bit PSoC1 (Programmable System-On Chip) families, including automotive, except CY8C25/26xxx devices.

CY8C20x34
CY8C20xx6A
CY8C21x23
CY8C21x34
CY8C22xxx/CY8C21x45
CY8C23x33
CY8C24x23A/CY8C24x33
CY8C24x94
CY8C27x43
CY8C28xxx
CY8C29x66
CY8C95xx